Test Procedures - Club Car Precedent 2004 Maintenance And Service

ELECTRICAL SYSTEM AND TESTING

TEST PROCEDURES

Using the following procedures, the entire IQ electrical system can be tested without major disassembly of the vehi-
cle.
∆
WARNING
• If wires are removed or replaced, make sure wiring and wire harness is properly routed and
secured. Failure to properly route and secure wiring could result in vehicle malfunction,
property damage, personal injury, or death.
For many tests the electronics module cover must be removed to gain access to the various components that
are mounted on the component mounting plate. Remove screw (1) and remove cover (2) (Figure 11-7,
Page 11-17). See following WARNING.
∆
WARNING
• Shorting of battery terminals can cause personal injury or death.
- Do not place component mounting plate directly on top of batteries when removing or
installing plate.
- Remove plate from vehicle completely.
1
Figure 11-7 Electronic Module Cover
After test procedures are completed, be sure to replace the cover. See following CAUTION.
CAUTION
• Exposure to water may damage electronic components.
- Do not operate vehicle without the cover properly installed.
- Do not direct a water stream in area of the cover.
2
COMPONENT
MOUNTING
PLATE
2004 Precedent IQ System Golf Car Maintenance and Service Manual
11
Test Procedures
Page 11-17