Kick Plate And Charger Bezel; Kick Plate And Charger Bezel Removal; Kick Plate And Charger Bezel Installation - Club Car Precedent 2004 Maintenance And Service

BODY AND TRIM

KICK PLATE AND CHARGER BEZEL

See General Warnings, Section 1, Page 1-1.

KICK PLATE AND CHARGER BEZEL REMOVAL

1. If charger bezel (4) requires removal, use charger bezel tool (CCI P/N 102562401) to remove bezel from
the kick plate (Figure 4-4, Page 4-8).
2. Remove floor mat. See Floor Mat and Retainers, Section 4, Page 4-6.
3. Remove three screws (1) that hold the kick plate (2) to the vehicle.
4. Remove the two front screws (3) that hold the beauty panel to the vehicle. Raise the forward portion of
the rear beauty panel to disengage it from the tabs on the upper portion of the kick plate.
5. Remove kick plate from vehicle.

KICK PLATE AND CHARGER BEZEL INSTALLATION

1. Position the kick plate (2) on the vehicle and secure with three screws (1) (Figure 4-4, Page 4-8). Ensure
front lower edge of rear beauty panel mates with the kickplate. Tighten screws to 3.3 ft-lb (4.5 N·m).
2. Install two front screws (3) to secure the rear beauty panel. Tighten screws to 3.7 ft-lb (5 N·m).
3. Install floor mat. See Floor Mat and Retainers, Section 4, Page 4-6.
4. Snap charger bezel (4) in place on the kick plate.
2004 Precedent IQ System Golf Car Maintenance and Service Manual
Kick Plate and Charger Bezel
Page 4-7
4