Onboard Computer (Obc) - Club Car Precedent 2004 Maintenance And Service

ELECTRICAL COMPONENTS
3. Remove 4 wires from solenoid.
4. Loosen both solenoid mounting screws (2) (Figure 12-10, Page 12-12).
5. Rotate solenoid up in front and slide off of the component mounting plate.
Solenoid Installation
1. Mount solenoid onto component mounting plate with screws (2) (Figure 12-10, Page 12-12).
2. Tighten screws (2) to 5.5 ft-lb (7.5 N·m).
3. Connect yellow (4) and red (5) wires (Figure 12-9, Page 12-10). Tighten to 72 - 84 in-lb (8 - 9.5 N·m).
4. Install electronics module cover. See Electronics Module Cover Installation on page 12-5.
5. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.

ONBOARD COMPUTER (OBC)

See General Warnings, Section 1, Page 1-1.
Testing the Onboard Computer
See Section 11, Test Procedure 2, Page 11-19, Test Procedure 10, Page 11-36, and Test Procedure 11,
Page 11-37.
Onboard Computer Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-2.
2. Remove electronics module cover. See Electronics Module Cover Removal on page 12-5.
3. Disconnect wires (Figure 12-9, Page 12-10).
4. Loosen, but do not remove, the two self-tapping screws (3) holding OBC to component mounting plate
(Figure 12-10, Page 12-12).
5. Slide OBC upwards to align heads of self-tapping screws (3) with the two key holes in the OBC face plate
and remove OBC.
Onboard Computer Installation
1. Install the OBC onto the component mounting plate by aligning the two holes on the OBC face plate with
two holes on component mounting plate. Slide OBC down and align heads of self-tapping screws (3) with
smaller part of two holes in OBC face plate (Figure 12-10, Page 12-12). Tighten screws to 5.5 ft-lb (7.5
N·m).
2. Connect wires (Figure 12-9, Page 12-10). Make sure all connections are fully seated and boot on gray
sense lead is properly seated.
3. Install electronics module cover. See Electronics Module Cover Installation on page 12-5.
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.
2004 Precedent IQ System Golf Car Maintenance and Service Manual
Onboard Computer (OBC)
Page 12-13
12