Axle Bearing - Club Car Precedent 2004 Maintenance And Service

16B
TRANSAXLE (TYPE K)

AXLE BEARING

Axle Bearing Removal
1. Remove the retaining ring (7) from the axle shaft (Figure 16b-4, Page 16b-3).
2. Place a bearing puller wedge attachment (CCI P/N 1012812) on the axle shaft between the wheel mount-
ing flange and the bearing.
3. Press bearing (5) and collar (4) off together (Figure 16b-5, Page 16b-4). See following CAUTION.
CAUTION
• Do not tighten the bearing puller wedge attachment against the axle shaft. This could damage
the axle shaft when pressing off the bearing and collar.
NOTE: It may be necessary to heat the collar before the collar can be removed.
BEARING
PULLER
WEDGE
ATTACHMENT
Figure 16b-5 Bearing and Collar
Axle Bearing Installation
1. If removed, place retaining ring (6) on axle shaft (1 or 2) (Figure 16b-4, Page 16b-3). The retaining ring
will be loose on the axle shaft until it is installed into the axle tube.
2. Apply two drops of Loctite
CAUTION
• Apply Loctite
from the bearing as the collar and bearing are pressed on. If Loctite gets on or in the bearing,
the bearing must be replaced.
• The collar should be removed no more than two times. If a bearing is removed a third time, the
shaft and collar will not give a proper fit.
3. Place the bearing and the collar on the shaft (note, this is a sealed bearing). See following CAUTION.
Page 16b-4 2004 Precedent IQ System Golf Car Maintenance and Service Manual
PRESS RAM
4
5
®
271 to the inside of the collar.
®
271 to inside of collar only, not to the shaft, so the Loctite will be pushed away
Axle Bearing and Shaft
AXLE SEAL
TOOL
AXLE SEAL
Figure 16b-6 Axle Seal Tool