Club Car Precedent 2004 Maintenance And Service page 195

TRANSAXLE (TYPE K)
Figure 16b-9 Disconnect Shocks
∆
WARNING
• Do not position fingers under motor when sliding motor off of the input shaft. Fingers may get
pinched when motor disengages.
11. Carefully remove the motor from the transaxle. Slide the motor away from the transaxle until the motor
spline becomes disengaged from the input shaft, then lift motor out. See preceding WARNING.
12. If a floor jack was used, pull floor jack from beneath the transaxle and allow the springs to rest on the floor.
13. Remove the U-bolts attaching the transaxle to the leaf springs (Figure 16b-11, Page 16b-7).
14. Carefully lift each end of the transaxle off its positioning pin (on the leaf spring) and slide the transaxle
to the rear and out of the vehicle.
15. Drain the lubricant from the transaxle and remove the axle shafts. See Axle Shaft and Oil Seal Removal
on page 16b-1. See following NOTE.
NOTE: Recycle or dispose of used oil or lubricant in accordance with local, state, and federal regulations.
16. Remove the brake assemblies if required. See Brake Cluster Removal, Section 6, Page 6-9.
VILLAGER 4
PRECEDENT
Figure 16b-11 Leaf Springs
2004 Precedent IQ System Golf Car Maintenance and Service Manual
Figure 16b-10 Shackles
MOTOR MOUNTING
INPUT
PINION
GEAR
DIFFERENTIAL
INTERMEDIATE
GEAR CASE
GEAR ASSEMBLY
Figure 16b-12 Motor Mounting Bolts
16B
Axle Bearing and Shaft
Remove bolt, then
rotate shackle
up and away
from spring.
BOLTS
Page 16b-7