Club Car Precedent 2004 Maintenance And Service page 178

16A
TRANSAXLE (TYPE G)
Axle Shaft and Oil Seal Removal, Continued:
3. Remove the rear wheel and brake drum. See Section 6 – Wheel Brake Assemblies. and Section 8 –
Wheels and Tires in the appropriate maintenance and service manual.
4. Using 90° internal snap ring pliers, remove the internal retaining ring (6) from the axle tube
(Figure 16a-5, Page 16a-3). See also Figure 16a-1, Page 16a-2.
5. Remove the axle, retaining ring, and bearing assembly by pulling the axle straight out of the housing.
6. If necessary, remove the axle oil seal and adapter ring.
6.1. Use a bearing puller (CCI P/N 1016417) to remove the axle seal and adapter ring from the axle tube
(Figure 16a-2, Page 16a-2). See following CAUTION and NOTE.
CAUTION
• Do not scar or damage the inside surfaces of the tube when removing the oil seal and adapter
ring. A damaged tube might have to be replaced.
NOTE: Do not discard the adapter ring. If the adapter ring is lost or damaged, the axle tube will have to be
replaced.
6.2. Use a press to separate the axle oil seal (15) from the adapter ring (39) (Figure 16a-3,
Page 16a-2). Retain the adapter ring and discard the oil seal.
7. Inspect the axle shaft assembly to be sure the bearing and collar have not slipped and are still seated
against the shoulder on the axle shaft.
Figure 16a-1 Axle Tube
Figure 16a-3 Axle Seal and Adapter Ring
Page 16a-2 2004 Precedent IQ System Golf Car Maintenance and Service Manual
ADAPTER
RING LIP
39
15
Figure 16a-2 Axle Seal and Adapter Ring Removal
Figure 16a-4 Axle Seal and Adapter Ring Installation
Axle Bearing and Shaft