Tow/Run Switch - Club Car Precedent 2004 Maintenance And Service

12
ELECTRICAL COMPONENTS
1
TOW/RUN
SWITCH BRACKET
Figure 12-5 Electronics Module Cover

TOW/RUN SWITCH

See General Warnings, Section 1, Page 1-1.
Testing the Tow/Run Switch
See Test Procedure 6, Section 11, Page 11-23.
Tow/Run Switch Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-2.
2. Remove the electronics module cover. See Electronics Module Cover Removal on page 12-5.
3. Remove Tow/Run switch boot/hex nut (1) (Figure 12-6, Page 12-7).
4. Remove Tow/Run switch (2) from bracket.
5. Disconnect the two wires (3) and remove switch.
Tow/Run Switch Installation
1. Installation is reverse of removal. Make sure flat on switch is aligned with the flat on bracket. Tighten Tow/
Run switch boot/hex nut (1) to 16 in-lb (1.8 N·m) (Figure 12-6, Page 12-7).
2. Install the electronics module cover. See Electronics Module Cover Installation on page 12-5.
3. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.
Page 12-6 2004 Precedent IQ System Golf Car Maintenance and Service Manual
2
ELECTRONICS
MODULE
Tow/Run Switch