Backrest And Structural Accessory Module - Club Car Precedent 2004 Maintenance And Service

BODY AND TRIM
Figure 4-5 Universal Accessory Mounting

BACKREST AND STRUCTURAL ACCESSORY MODULE

SAM Removal
1. If the vehicle has a canopy, the rear upright supports must be removed from the SAM.
2. Remove four bolts (4) to release the SAM (3) from the vehicle (Figure 4-6, Page 4-10)
SAM Installation
1. Position the SAM (6) over its mounting holes and secure with four screws (4). Tighten screws to 10.3 ft-
lb (14 N·m).
Backrest
The backrest (1) is secured to the SAM (3) with two screws (2) (Figure 4-6, Page 4-10). When replacing the
backrest, tighten screws (2) to 5.9 ft-lb (8 N·m).
Bag Rack Removal
1. Remove two screws (10) to release the bag hoop (6) and related components from the SAM (3)
(Figure 4-6, Page 4-10).
2. Bag strap (8) may be released by removing two plastic barrel connectors (9) and one screw (12).
3. Bag strap buckles (7) may be snapped out of bag hoop (6).
Bag Rack Installation
Installation is the reverse of removal. Tighten screw (12) to 4.8 ft-lb (6.5 N·m) and screws (10) 11.8 ft-lb (16
N·m).
Panel
The panel (11) is secured to the bag hoop assembly by three screws (12). Tabs on the upper edge of the panel
align with holes in the bag hoop (6) for installation purposes. Tighten screws (12) to 4.8 ft-lb (6.5 N·m) to
secure the panel.
ATTACHMENT
POINTS
2004 Precedent IQ System Golf Car Maintenance and Service Manual
4
Rear Body
Page 4-9