Electronics Module - Club Car Precedent 2004 Maintenance And Service

ELECTRICAL COMPONENTS
3
REVERSE
BUZZER
VIEWED FROM
UNDERSIDE OF
INSTRUMENT
PANEL
2
Figure 12-8 Reverse Buzzer

ELECTRONICS MODULE

See General Warnings, Section 1, Page 1-1.
While it is not necessary to remove the electronics module from the vehicle, access to individual components
may be easier with the module removed.
Electronics Module Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-2.
2. Remove the electronics module cover. See Electronics Module Cover Removal on page 12-5.
3. Remove three power-connection screws on top of the controller (1) and remove the wires from the screw
threads (Figure 12-9, Page 12-10).
4. Disconnect the 16-pin connector, 4-pin connector, and the spade connectors from the top of the control-
ler.
5. Remove two nuts on top of the solenoid (2) posts and remove the wires from the posts.
6. Disconnect the spade connectors on the front of the solenoid.
7. On driver side of the electronic module, separate the 6-pin connector and disconnect all leads to the on-
board computer (OBC) (3) and two wires to tow switch.
8. Lift the electronics module from the vehicle. See following WARNING.
∆
WARNING
• Shorting of battery terminals can cause personal injury or death.
- Do not place component mounting plate directly on top of batteries when removing or
installing plate.
- Remove plate from vehicle completely.
PINK
ORANGE/
1
4
WHITE
2004 Precedent IQ System Golf Car Maintenance and Service Manual
12
Electronics Module
Page 12-9