Club Car Precedent 2004 Maintenance And Service page 182

16A
TRANSAXLE (TYPE G)
Transaxle Removal, Continued:
Figure 16a-8 Disconnect Shocks
9. If a chain hoist was used to raise the vehicle, lift the vehicle high enough to permit easy access and clear-
ance for removal of the motor. If a floor jack was used to raise the vehicle, lower the transaxle enough
to permit easy access and clearance for removal of the motor.
10. Remove the three motor mounting bolts (Figure 16a-11, Page 16a-6), and the motor positioning bolt
(Figure 16a-12, Page 16a-7), mounting the motor to the transaxle. See following WARNING.
∆
WARNING
• Do not position fingers under motor when sliding motor off of the input shaft. Fingers may get
pinched when motor disengages.
VILLAGER 4
PRECEDENT
Figure 16a-10 Leaf Springs
Page 16a-6 2004 Precedent IQ System Golf Car Maintenance and Service Manual
Figure 16a-9 Shackles
MOTOR MOUNTING
INPUT
PINION
GEAR
INTERMEDIATE DIFFERENTIAL
GEAR ASSEMBLY GEAR CASE
Figure 16a-11 Motor Mounting Bolts
Transaxle
Remove bolt, then
rotate shackle
up and away
from spring.
BOLTS