Control Arm Removal - Club Car Precedent 2004 Maintenance And Service

7
STEERING AND FRONT SUSPENSION
Kingpin and Steering Spindle Installation, Continued:
5. Attach the tie rod ends (12) to the spindle tabs, install and tighten the nuts (14) to 70 ft-lb (95 N·m). Install
the retaining pins (15) (Figure 7-18, Page 7-15).
6. Install front hub and wheel. See Hub Installation on page 7-18.

CONTROL ARM REMOVAL

1. Loosen lug nuts on both front wheels and raise front of the vehicle with a chain hoist or floor jack. Place
jack stands under the front aluminum rails of the vehicle frame and lower the vehicle onto the jack stands.
2. Remove wheel.
3. Remove bolts (17) and move rack and pinion to allow clearance for bolt (19) (Figure 7-18, Page 7-15).
4. Remove bolts (11 and 19).
5. Remove the control arm (6).
6. Inspect the bushings (7) and sleeves (8 and 9) in the control arm and replace them if necessary.
Page 7-14 2004 Precedent IQ System Golf Car Maintenance and Service Manual
Front Suspension Components