Electronics Module Cover - Club Car Precedent 2004 Maintenance And Service

ELECTRICAL COMPONENTS
∆
WARNING
• Make sure that the vehicle operates in the forward direction when the Forward/Reverse switch
is in the FORWARD position.
• Make sure that the vehicle operates in the reverse direction when the Forward/Reverse switch
is in the REVERSE position. The reverse buzzer will sound as a warning when the Forward/
Reverse switch is in REVERSE.
• Make sure that the vehicle does not operate when the Forward/Reverse switch is in the
NEUTRAL position.

ELECTRONICS MODULE COVER

See General Warnings, Section 1, Page 1-1.
The electronics module cover needs to be removed to gain access to the electronics module, the Tow/Run
switch, and hour meter.
Electronics Module Cover Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-2.
2. Remove the screw (1) that holds the cover (2) over the electronics module (Figure 12-5, Page 12-6).
3. Hold battery wire out of way and lift cover (2) off the vehicle.
Electronics Module Cover Installation
1. Hold battery wire out of way and place cover (2) over the electronics module.
2. Install screw (1) to secure cover in place. Tighten screw to 3.4 ft-lb (4.6 N·m).
CAUTION
• Exposure to water many damage electronic components.
- Do not operate vehicle without this cover properly installed.
- Do not direct water stream in the area of the cover.
3. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.
2004 Precedent IQ System Golf Car Maintenance and Service Manual
Electronics Module Cover
Page 12-5
12