Battery Warning Light - Club Car Precedent 2004 Maintenance And Service

ELECTRICAL COMPONENTS

BATTERY WARNING LIGHT

See General Warnings, Section 1, Page 1-1.
Testing the Battery Warning Light
See Test Procedure 18, Section 11, Page 11-42.
Battery Warning Light Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-2.
2. Remove instrument panel. See step 2 of Key Switch Removal on page 12-1.
3. Disconnect the wires at the warning light.
4. Press the two retaining tabs (11) and remove the light from the center dash (Figure 12-3, Page 12-3).
Battery Warning Light Installation
1. Install in reverse order of removal.
2. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.
Figure 12-3 Battery Warning Light
2004 Precedent IQ System Golf Car Maintenance and Service Manual
11
12
Battery Warning Light
Page 12-3