Remote Switch; Switch; Removal; Installation - Chrysler Dodge Caravan 2002 Manual

RS

REMOTE SWITCH

DIAGNOSIS AND TESTING - REMOTE SWITCH
(1) Remove power mirror switch. (Refer to 8 -
ELECTRICAL/POWER MIRRORS/POWER MIRROR
SWITCH - REMOVAL).
(2) Disconnect wiring harness at switch connector.
(3) Using a ohmmeter, test for continuity between
the terminals of the switch (Fig. 2).
Fig. 2 Mirror Switch
MIRROR SWITCH TEST
MIRROR SELECT SWITCH IN "LEFT"
POSITION
Move
Button
UP
LEFT
DOWN
RIGHT
MIRROR SELECT SWITCH IN "RIGHT"
POSITION
Move
Button
UP
LEFT
DOWN
RIGHT
LAMP
Continuity Between
PIN 9 - PIN 12,
PIN 6 - PIN 11,
PIN 9 - PIN 13
PIN 9 - PIN 7,
PIN 6 - PIN 11,
PIN 9 - PIN 8
PIN 9 - PIN 6,
PIN 12 - PIN 11,
PIN 13 - PIN 11
PIN 9 - PIN 6,
PIN 7 - PIN 11,
PIN 8 - PIN 11
Continuity Between
PIN 9 - PIN 13,
PIN 1 - PIN 11,
PIN 9 - PIN 12
PIN 9 - PIN 8,
PIN 1 - PIN 11,
PIN 9 - PIN 7
PIN 9 - PIN 1,
PIN 13 - PIN 11,
PIN 12 - PIN 11
PIN 9 - PIN 1,
PIN 8 - PIN 11,
PIN 7 - PIN 11
PIN 5 - PIN 11
(4) If results shown in the table are not obtained,
replace the switch.

REMOVAL

(1) Disconnect and isolate the battery negative
cable.
(2) Remove instrument panel lower cover.
(3) From behind
depress retaining tabs and push switch from instru-
ment panel.
(4) Disconnect wire connector from power mirror

switch.

(5) Disengage lock tabs above and below the mir-
ror switch.
(6) Remove power mirror switch from headlamp
switch bezel.

INSTALLATION

(1) Install power mirror switch to the headlamp
switch bezel.
(2) Connect wire connector to the power mirror
switch.
(3) Insert headlamp switch assembly into instru-
ment panel.
(4) Install instrument panel lower cover.
(5) Connect battery negative cable.
SIDEVIEW MIRROR
REMOVAL
For service procedures, (Refer to 23 - BODY/EXTE-
RIOR/SIDE VIEW MIRROR - REMOVAL).
POWER FOLDAWAY MIRROR
SWITCH - EXPORT
DESCRIPTION
These vehicles may be equipped with Power Fold-
away Mirrors. This feature allows both the driver
and passenger side view mirrors to fold inward
(retract) on demand. The vehicle has an additional
switch located on the steering column that controls
the folding function of the mirror assembly (Fig. 3).
The fold-away side view mirror is attached to the
vehicle's door in the same manner as mirrors without
the fold-away option. The fold-away mirrors unique
option is the internal motor which allows the mirrors
to fold inward on demand. The fold-away mirror
motor is not serviceable separately and if a motor is
found to be faulty the entire side view mirror must
be replaced.
POWER MIRRORS
headlamp switch assembly,
8N - 49