Table of Contents
Advertisement
Caution:
If dosing is initiated when the indication is > LO , after reaching the
indication below LO output (outputs)will be automatically switched on.
Subsequent dosing process can be started when indication goes below
LO.
24.8.5. Tarring mode setting
The parameter <P7.4.5 TARRING> allows to enable/disable automatic
tarring in DOSING mode.
Procedure:
• Enter <P7 WORK MODES> and then:
Return to weighing:
See 11.3.
24.8.6. Corrections
Work mode <DOSAGE> can have automatically corrected nominal mass
in the dosing procedure that allows to optimize the procedure considering
pressure changes of dosed substance in the hopper or other container.
In parameters' group <P7.4.6 DOSING CORRECTIONS> users can set
parameters that refer to introducing mass correction.
- 113 -
Advertisement
Table of Contents
