Point In Mass Form In Ean-13 Code; Setting Of The Number Of Labels To Print - RADWAG WPW/E User Manual

24.9.7. Point in mass form in EAN-13 code

In common systems of retail EAN13 bar codes are used. The sellers use
weights that shows mass in kilos with 3 places after dot accuracy. There
are 5 places in the mass code. That makes impossible to use weights with
100 and more kilos range (2 places after dot is approved only). In these
cases the bar code is not printed. The balance cannot relate mass to
required standards in the codes. Parameter <P7.5.7 EAN POINT. POS.>
is optional and changes place of the dot in the mass form in EAN13 code.
Notice:
Please remember that changing the mass form in EAN13 code can cause
wrong reception by external systems. Sometimes the external systems
rd
expects that the dot is on the 3 place in the mass form.
Procedure:
• Enter parameters group <P7 WORK MODES> following
step 11.2. of the manual and then:
Return to weighing:
See ch. 11.3 - return to weighing.

24.9.8. Setting of the number of labels to print

In the parameter <P7.5.8 NO OF LABELS> user defines the amount
of labels. They are printed on the printer connected to the weight.
- 122 -