RADWAG WPW/E User Manual page 152

4. During installation turn your attention to plastic columns. They should
be placed one side in mounting holes in the main board and the other
side in the mounted module DP1.
Installing DP1 module on the main board of PUE C41H
5. Led a tensometer cable through the PG7 gland next to the gland
of main platform;
6. Put on a ferrite core on the cable (core of appropriate internal
diameter);
7. Turn the wires on the ferrite core (5 turns);
8. Solder the wires to the pads on the DP1. Use soldering iron
(no solder guns or Rother inductive devices);
9. Fasten the cable to the housing using a band clip (to the screwed
terminal on the back wall of the housing);
10. Screw down the back wall.
- 152 -