Record - Qvis iBox nvr User Manual

Important
The alarm output port should not be connected to high power load directly (It shall be less
than 1A), to avoid high current which may result in relay damage. Please use the co-
contactor to check the connection between the alarm output port and the load.
Please refer to the following sheet for detailed information:
Parameter Function
Alarm output The alarm output channel may vary. The interface here is for
reference only.
Please click the corresponding number and then click the trigger
button.
Trigger Enable/disable alarm output.
Please note once you activate an alarm manually, you need to
click the output channel number again and then click trigger button
to disable it. Otherwise the alarm can not be cancelled.
Search alarm output status.
Refresh
7.4.3.4

Record

Record control interface is shown in Figure 7-49.
The bit stream type includes main stream and extra stream:
© Copyright Qvis ®. All documentation rights reserved.
Figure 7-49 Record
132