Qvis iBox nvr User Manual page 88

Important:

eSATA also supports this function, you can manage e-SATA hard disks as local hard drives.

Current series software version can only set the HDD group operation of the read-write HDDs.
It does not apply to the redundancy HDD.
HDD Setting
Click the button 'HDD Settings' at the top right corner of the Figure 5-77, the system will pop up an
interface as below. See Figure 5-79.
The number of hard disks from numbers 1 to 2 are shown in the "HDD No." column (It is to show
the maximum HDD amount you can install). If the serial number is highlighted, it means this
interface has had access to the hard disk. If it is not highlighted then it does not have access to
the hard disk.
The "HDD Group" column lists the HDD Group number of the currently connected hard disks. You
can select HDD group name from the dropdown list and then click 'Save' button.
Please note that one HDD corresponds to one group, while one group can have many HDDs.
The HDD group Number corresponds to the HDD port, the HDD group number may vary if you
change the HDD.
Important: Once you change the HDD Group settings, system will pack the recorded video files &
snapshots, and then reboot.
Channels Setting
Click the button named 'Channels Settings' at the top right corner of the Figure 5-77, the system
will pop up an interface as shown in Figure 5-80.
You can set the HDDs to main stream, extra stream or snap pictures respectively. The main
stream and extra stream of one channel can be saved to different groups.
© Copyright Qvis ®. All documentation rights reserved.
Figure 5-79
79