Qvis iBox nvr User Manual page 55

After you enable the trusted sites function, only the IP listed below can access current NVR. If you
enable blocked sites function, the following listed IP addresses cannot access current NVR.

Enable: If you highlight the box here, you can check the trusted site and blocked sites
functions. You cannot see these two modes if the Enable button is highlighted in grey.

Type: You can select 'Trusted site' and 'Blacklist' from the dropdown list. You can view the IP
address on the following column.

Start address/end address: Select one type from the dropdown list, you can input the IP
address in the start and end address. Now you can click to add the IP address or add IP
section to the list.
For the newly added IP address, this can enable a status by default. Remove the √
a)
before the item then current item if not in the list.
b) System supports up to a maximum of 64 items.
c) Address column supports IPv4 or IPv6 format. If it is an IPv6 address, the system can
optimise it.
For example: system can optimise:
aa:0000: 00: 00aa: 00aa: 00aa: 00aa: 00aa
as
aa:: aa: aa: aa: aa: aa: aa.
d) System automatically removes space if there is any before or after the newly added IP
address.
e) System only checks start address if you add an IP address. The system checks the start
and end address if you add IP section and the end address shall be larger than the start
address.
f) System may check if a newly added IP address exists or not. The system does not add it
to the list if the input IP address does not exist.

Delete: Click it to remove specified item.

Edit: Click it to edit start and end address. System can check the IP address validity after the
edit operation and implement IPv6 optimisation.
© Copyright Qvis ®. All documentation rights reserved. 46