Abnormity - Qvis iBox nvr User Manual

Channel: It is to display the actual channel number of current NVR.
HDD Group: This is the SN of the HDD group management. For example, if you set two HDD
groups such as Group 1 and Group 2, you can see there are two options (1 or 2) within the HDD
group dropdown list.
Important:

Please make sure you have set the HDD group for each channel, otherwise you cannot save
current setup!

Once you change the HDD Group settings, system will pack the recorded video files and then
reboot!
Tip: There is an easy way for you to test whether the records from the corresponding channel is
saved in the specified HDD. You can remove the HDD and then check to see if the channel can
record or not. If you find that the channel has not recorded you cannot search for previous
records.

5.7.2 Abnormity

Abnormity interface is shown in Figure 5-81.

Event type: There are several options for you to choose from such as disk error, no disk,
disconnection, IP conflict, etc.

Alarm output: Please select the alarm activation output port (multiple choices).

Latch: Here you can set the corresponding delaying time. The value ranges from 10s-300s.
System automatically delays in turning off alarm with the specified seconds and activates
output after external alarm has been cancelled.

Show message: system can pop up a message in the local screen to alert you when an
alarm is triggered.

Alarm upload: System can upload the alarm signal to the network (including alarm centre)
if you enabled current function.

Send email: System can send out an email to alert you when an alarm is triggered.

Buzzer: Highlight the icon to enable this function. The buzzer beeps when an alarm occurs.
© Copyright Qvis ®. All documentation rights reserved.
Figure 5-80
80