Web Operation; General Introduction; Preparation - Qvis iBox nvr User Manual

7 Web Operation

7.1 General Introduction

The device's web provides a channel monitor menu tree, search, alarm setup, system setup, PTZ
control and monitor window.

Preparation

7.1.1
Before log in, please make sure:

Network connections are correct.

NVR and PC network setup are correct. Please refer to network setup (main-
menu->setting->network)

Use initiate a network ping: ***.***.***.*** using the NVR IP address, to check connection is
OK or not. Usually the return TTL value should be less than 255.

Open the web browser and then input NVR IP address.

System can automatically download latest web control and the new version can overwrite the
previous one.

If you want to un-install the web control, please run uninstall webrec2.0.bat. Or you can go to
C:\Program Files\webrec to remove the folder. Please note, before you un-install, please
close all web pages, otherwise the un-installation might cause an error to occur.

Current series product supports various browsers such as Safari, firebox browser, Google
browser. Device only supports 1-channel monitors on an Apple based operating system.
About PoE address setup, operation and allocation.
1. Insert PoE
After you connect the PoE, the device may try to set a corresponding IP address from the Switch
network adapter. At the start, the system will try to set via an ARP ping. It then uses the DHCP if it
finds that the DHCP is enabled. After successfully setting the IP address, system may use the
Switch to send out a broadcast. The system will think the connection is OK when there is any
response made. Now the system will try to login the newly found IPC. When you check the
interface, you will see the corresponding digital channel is active. You will also see a small PoE
icon at the top left corner, which will allow you to view the PoE channel, PoE port information and
etc from the connection list of the remote device interface (Chapter 5.6.11). For the IP search list,
you need to click the IP search to display or refresh.
2. Remove PoE
After you remove the PoE, you will see the corresponding digital channel becomes idle (disabled).
On the remote device interface, it is removed from the connected list. For the IP search list, you
need to click the 'IP Search' button to refresh.
© Copyright Qvis ®. All documentation rights reserved. 92