Alarm Center; Snmp - Qvis iBox nvr User Manual

5.6.5.11

Alarm center

Interface is pre-reserved for the users to develop this function.
5.6.5.12

SNMP

SNMP is an abbreviation of Simple Network Management Protocol. It provides the basic
network management frame for the network management system. The SNMP is widely used in
many environments. It is used in many network devices, software and systems. You can setup the
following interface. See Figure 5-51.
Please enable the SNMP function. Use the corresponding software tool (MIB Builder and
MG-SOFT MIB Browser. You still need two MIB files: BASE-SNMP-MIB, NVR-SNMP-MIB) to
connect to the device. You can get the device's corresponding configuration information after
successfully connecting.
Please follow the steps listed below to configure.
1. In Figure 5-51, check the box to enable the SNMP function. Input the IP address of the PC
that is running the software in the Trap address. You can select the default setup for the rest
items that need to be filled in.
2. Compile the above mentioned MIB files, via the software MIB Builder.
3. Run MG-SOFT MIB Browser to load the file from the previous step to the software.
4. Input the device IP that you want to manage within the MG-SOFT MIB Browser. Please set
the corresponding version for your future reference.
5. Open the tree list on the MG-SOFT MIB Browser; you will then be able to view the device
configuration, which includes the number of video channels, audio channels, application
version, etc.
© Copyright Qvis ®. All documentation rights reserved.
Figure 5-51
58