Qvis iBox nvr User Manual page 74

Fn button to switch between the arm mode and disarm mode. In arm mode, you can click the
direction buttons to move the green rectangle to set the motion detection zone. After you
completed the setup, please click ENTER button to exit current setup. Do remember to click
the save button to save current setup. If you click the ESC button to exit the region setup
interface system will not save your zone setup.

Sensitivity: System supports up to 6 levels. The sixth level has the highest sensitivity.

Period: Click set button, you can see an interface is shown as in Figure 5-. Here you can set
for business day and non-business day. In Figure 5- click set button, you can see an interface
is shown as in Figure 5-. Here you can set your own setup for business day and non-business
day.
© Copyright Qvis ®. All documentation rights reserved.
Figure 5-60
Figure 5-63
Figure 5-64
65