Qvis iBox nvr User Manual page 48


Overlay: Click overlay button, you can see the interface pop up box shown in Figure 5-25.

Cover area (Privacy mask): This allows you to set the privacy mask section. You can
drag you mouse to set the proper section size. In one channel video, system supports up
to 4 zones in one channel.

Preview/monitor: privacy mask has these two types to choose from. Preview means the
privacy mask zone cannot be viewed by the user when system is set to preview status.
Monitor means the privacy mask zone cannot be viewed by the user when system is set
to monitor status.

Time display: You can choose to view the displays time or not during playback. Please
click the set button and then drag the title to the corresponding position on the screen.

Channel display: You can choose to view the system displays channel number or not
during playback. Please click the set button and then drag the title to the corresponding
position in the screen.

Copy：After you complete the setup, you can click the Copy button to copy current setup to
other channel(s). You can see an interface box shown in Figure 5-26. If you look at the
channel number in the small boxes you can see the current channel number is grey. Please
check the number to select the channel or you can check the box ALL. Please click the OK
button in Figure 5-26 and Figure 5-24 respectively to complete the setup.
Please note, once you check the 'All' box, you set the same encode setup for all channels.
Audio/video enable box overlay button and the copy button is shielded so that you cannot
select it (See Figure 5-27).
Please highlight icon
© Copyright Qvis ®. All documentation rights reserved.
Figure 5-25
Figure 5-26
to select the corresponding function.
39