Chapter 8: Installing Blackdiamond 8800 Series Module Options; Installing An S-Poe Daughter Card - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

8 Installing BlackDiamond 8800 Series Module
Options
This chapter includes the following sections:
Installing an S-POE Daughter Card on page 127
●
Installing an Option Card in the 8500-MSM24, MSM-48c, or 8900-MSM128 on page 130
●
This chapter describes how to install the following optional components on BlackDiamond 8800 series
modules:
S-POE daughter card on the G48Tc or G48Te2 I/O module (see next section)
●
S-G8Xc or S-10G1Xc port option card in the MSM-48c or 8900-MSM128 module (see
●

Installing an S-POE Daughter Card

The S-POE daughter card adds PoE functionality to the ports on a G48Tc, G48Te2, or 8500-G48T-e
I/O module.
You must remove the I/O module from the BlackDiamond 8800 series switch before you install the
S-POE card.
You need the following tools and equipment to install an S-POE card:
ESD-preventive wrist strap
●
#2 Phillips screwdriver
●
3/8-inch flat-blade screwdriver
●
To install the S-POE daughter card:
1 Attach the ESD-preventive wrist strap to your bare wrist. If the metal end is not already connected,
connect it to the ground receptacle at the top left corner of the chassis.
2 Remove the I/O module from the BlackDiamond 8800 series switch, following the instructions in
"Removing a BlackDiamond 8000 Series Module" on page
work surface.
3 Identify the daughter card connectors on the I/O module (see
BlackDiamond 8800 Series Switches Hardware Installation Guide
117. Set the module on an ESD-preventive
Figure 80).
page 130)
127