Broadcast-Limit - Zte ZXR10 Command Manual

Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
baudrate <baudrate>
no baudrate
<baudrate>
� The default baud rate of the asynchronous serial port v24 is
9600 bps.
� The default baud rate of the synchronous serial port v24 is
9600 bps.
� The default baud rate of the synchronous serial port v35 is 64
Kbps.
Since the baud rate ranges supported by the synchronous and
asynchronous serial ports are different, in case of synchronous
and asynchronous serial port switchover, if the current work mode
does not support the existing baud rate, the baud rate is modified
to the default one in the current work mode.
� The baud rates supported by the asynchronous serial port
v24 contain 300, 1200, 2400, 4800, 9600, 19200, 38400 and
57600.
� The baud rates supported by the asynchronous serial port v24
contain 1200, 2400, 4800, 9600, 19200 and 38400.
� The baud rates supported by the asynchronous serial port v35
range from 64 K to 2000 K, ascending by the unit of 64 K.
When the asynchronous serial port is set to work at 300 bps,
a ppp link cannot be set successfully.
� It is only applied to ZXR10 GAR, ZXR10 ZSR.
This example describes how to set the baud rate of the syn-
chronous serial port serial_1/1 to 19200 bps.
ZXR10(config)#interface serial_1/1
ZXR10(config-if)#baudrate 19200

broadcast-limit

Use this command to configure the limit percentage of the Ethernet
port to broadcast packet. Restore default with the no command.
Interface configuration
broadcast-limit <percent-value>
no broadcast-limit
<percent-value>
no broadcast-limit and broadcast-limit 100 have the same
function.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
The baud rate of serial port, in bps.
Limit percentage of broadcast packet in the
range of 1~100 and the default value is 100
11