Show Opticalinfo; Show Optical-Info Brief - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instruction
monitor session

show opticalinfo

Use this command to display the information of optical module.
EXEC
show opticalinfo [interface <interface-name>]
<interface-name>
It is only applied to physical interfaces.
This example shows how to display optical module information of
interface cpos3.
ZXR10#sho opticalinfo interface cpos3_5/1
The opticalModule is online
The transceiver type
SONET Compliance Codes : no compliance
Gigabit Ethernet Compliance Codes : 1000BASE-lx
Infiniband Compliance Codes : no compliance
Transfers distance :9/125
Laser Wavelength : 1310 nm
Measured RX input Power
Measured TX output Power :
Vendor name : PHOTON
Vendor PN : PT7320-51-1TP
Vendor rev : 2.0
Vendor SN : A0000244588
The displayed domain and contents vary with optical modules. The
optical information is provided by drivers.

show optical-info brief

Use this command to display the optical module information: tem-
perature, voltage, circuit, sending and receiving power. It supports
the view of single port and veneer.
Privileged EXEC
show optical-info brief [ npc <slot>| interface < interface-n
ame >]
interface <
interface-name >
npc <slot>
It only supports the physical interface.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
Interface name
: SFP
μm fiber 10000 (m)
μm fiber 0 (m)
50/125
62.5/125 μm fiber 0 (m)
copper line 0 (m)
: unsupported
unsupported
the interface name
the slot number of the line card
55