National Bit; Native Vlan Id - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
set interface multicast-limit

national bit

Use this command to set parameter national bit of the CE3 chan-
nel. Restore the default with the no command.
Channel configuration

national bit {0|1}

no national bit
0
1
The default is 1.
It is applied to ZXR10 GER and ZXR10 T64E/T128.
This example describes how to set national bit of the CE3 channel
to 0.
ZXR10(config)#controller ce3_3/1
ZXR10(config-control)# national bit 0

native vlan id

Use this command to configure dynamic vlan id on Ethernet inter-
face.
Interface configuration
native vlan id < vlan-id >
no native vlan id
<vlan-id>
The default value is 4095.
It is applied to megabit and gigabit interfaces.
This example shows how to set the native vlan id of a megabit
interface fei_1/1.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#native vlan id 111
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
Sets national bit to 0
Sets national bit to 1
VLAN number, in the range of 1~4095.
39