Stm-1; Stopbits - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example

stm-1

Use this command to create cpos48 sub interfaces when the
cpos48 interface is configured to sdh mode.
P48sdh controller configuration configuration
stm-1 <number-list>
no stm-1 <number-list>
<number-list>
It is applied only to ZXR10 T128.
�
This example shows how to create a cp48 sub interface that
takes up No.1 channel.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sdh
ZXR10(config-control)#stm-1 1
� This example shows how to create a cp48 sub interface that
takes up 1-4 channels.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sdh
ZXR10(config-control)#stm-1 1-4
� This example shows how to create a cp48 sub interface that
takes up 1-16 channels.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sdh
ZXR10(config-control)#stm-1 1-16

stopbits

Use this command to set the interval for the asynchronous serial
port to transmit every two characters (here the time is measured
by bit).
Interface configuration

stopbits {1 | 2}

1
2
The default is 1.
It is applied only to ZXR10 GAR, ZXR10 ZSR.
This example describes how to set the stopbits of asynchronous
serial port serial_1/1 to 1.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
Ranging from 1~16, such as 1-4, 5-8, 9-12,
13-16 and 1-16.
Stops the time for the asynchronous serial
port to transmit 1 bit
Stops the time for the asynchronous serial
port to transmit 2 bits
61