Set Interface Switch-Attribute; Set Interface Unknowcast-Limit - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Example
speed

set interface switch-attribute

Use this command to set the attributes of Layer 2 and Layer 3 on
megabit interfaces and gigabit interfaces in batch.
Global configuration
set interface switch-attribute {enable | disable}<port-list>
enable
disable
<port-list>
All Ethernet ports (currently, fei and gei). For routers, default
value is Layer–3 attributes. For switches, default value is switch-
ing attribute.
Currently, only fei, gei and smartgroup interfaces support this
function.
This example shows how to set the Layer 2 attribute on fei_1/1,
fei_1/2 and fei_1/3.
ZXR10(config)#set interface switch-attribute enable fei_1/1-3
switch-attribute {enable | disable}
set interface unknowcast-li
mit
Use this command to set the limit rate (in percent) to unknown
packets on Ethernet ports in batch.
Global configuration
set interface unknowcast-limit <precent-value><port-list>
<precent-value>
<port-list>
This example describes how to set the limit rate to unknown pack-
ets on ports fei_1/1, fei_1/2 and fei_1/3 to 80%.
ZXR10(config)#set interface unknowcast-limit 80 fei_1/1-3
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
Configuring Layer–2 Ethernet interface
attributes
Configuring Layer–3 Ethernet interface
attributes
Port list of the batch configuration
Rate limit to unknown packets, ranging
1–100, 100 by default
Specifies the port list of the batch
configuration
49