Vtg T1 Channel-Group Timeslots; Vtg T1 Clock Source - Zte ZXR10 Command Manual

ZXR10 Command Manual (Basic Configuration Volume II)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
72 Confidential and Proprietary Information of ZTE CORPORATION
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sonet
ZXR10(config-control)#sts-1 1
ZXR10(config-control)#mode vt-2
ZXR10(config-control)#vtg 1 e1 1 framing frame
ZXR10(config-control)#vtg 1 e1 1 framing crc4
vtg t1 channel-group
timeslots
Use this command to create a T1 channel when the cpos3 inter-
face is configured with the sonet mode and the sts-1 is configured
with the vt-15 mode. Delete the specified T1 channel with the no
command.
Channelization configuration
vtg <vtg-number> t1 <line> channel-group <channel-numb
er> timeslots <timeslots>
no vtg <vtg-number> t1 <line> channel-group <channel-num
ber>
vtg <vtg-number>
t1 <line>
channel-group
<channel-number>
timeslots <timeslo
ts>
It is applied only to ZXR10 GER.
This example describes how to create a T1 channel.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sonet
ZXR10(config-control)#sts-1 1
ZXR10(config-control)#mode vt-15
ZXR10(config-control)#ctg 1 t1 1 channel-group 1 timeslots 1-24

vtg t1 clock source

Use this command to set the clock source of T1 channel when the
cpos3 interface is configured with the sonet mode and the sts-1
is configured with the vt-15 mode. Restore the default value with
the no command.
Channelization configuration
vtg <vtg-number> t1 <line> clock source {internal | line}
vtg number, 1 ~ 7.
T1 number, 1 ~ 4.
T1 channel number, only 1.
Timeslot number distributes the timeslots of
1 to 24 to a channel on the one-off basis.