Vrrp Track; Command Modes - Zte ZXR10 Command Manual

Related
Commands
Purpose

Command Modes

Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
show vrrp

vrrp track

Use this command to set the tracking function of the VRRP uplinks.
Restore the default with the no command.
Interface configuration
vrrp <group> track <track-num>{(decrement<priority>) | bfd
{priority-down | switch} }
no vrrp <group> track <track-num>
<group>
<track-num>
decrement
<priority>
bfd
priority-down
switch
If this area is configured, it is enabled by default.
Set the link status in which the VRRP group shall perform the track.
If the interface turns down from up, the priority will be automati-
cally reduced. If the interface turns up from down, the priority will
be automatically raised to quicken the active/standby election of
VRRP.
This example describes how to set VRRP to track the link status of
interface vlan2.
ZXR10(config)#track 1 interface vlan2 line-protocol
ZXR10(config)#interface vlan 1
ZXR10(config-if)#vrrp 1 track 1
show vrrp
track
show track
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 6 VRRP Configuration
Virtual router ID, 0 ~ 255
ID of the track group, 1 ~ 256
Reduces the priority (optional). 20 by default
Priority reduced, ranging from 1 to 254
The corresponding track type is BFD.
The policy that reduce the priority level to 1.
The policy that switch state immediately.
135