E1 Loopback; E1 National Bits - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example

e1 loopback

Use this command to set loopback mode of E1 channel. Restore
default with the no command.
Channelization configuration
e1 <line> loopback {local | remote {payload | network}}
no e1 <line> loopback
<line>
local
remote payload
remote network
Do not support the loopback function by default.
It is applied to ZXR10 GER and ZXR10 T64E/T128.
This example describes how to configure the loopback mode of E1
channel 1 to local loopback.
ZXR10(config)#controller ce3_3/1
ZXR10(config-control)#e1 1 loopback local

e1 national bits

Use this command to set the national bits parameter of E1 channel.
Restore default with the no command.
Channelization configuration
e1 <line> national bits <pattern>
no e1 <line> national bits
<line>
<pattern>
It is applied to ZXR10 GER and ZXR10 T64E/T128.
This example describes how to configure national bits of E1 chan-
nel 1 as 1.
ZXR10(config)#controller ce3_3/1
ZXR10(config-control)#e1 1 national bits 1
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
E1 number, in the range of 1~16
Sets the loopback mode of e1 channel to local
loopback mode
Sets the loopback mode of e1 channel to
remote payload mode
Sets the loopback mode of e1 channel to
remote network mode
E1 number, in the range of 1~16
0~31, 0 by default
21