Hybrid-Attribute; Interface - Zte ZXR10 Command Manual

ZXR10 Command Manual (Basic Configuration Volume II)
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
28 Confidential and Proprietary Information of ZTE CORPORATION
Only when interface T1 is framing format, the superframe and the
extended-superframe can be configured.
This example describes how to configure the framing format on T1
interface board.
ZXR10(config)#control1er ct1_4/1
ZXR10(config-control)#framing frame
ZXR10(config-control)#framing superframe
ZXR10(config-control)#framing extended-superframe
ZXR10(config-control)#framing unframe

hybrid-attribute

Use this command to configure optical and electrical attributes of
the gigabit Ethernet port.
Interface configuration
hybrid-attribute {fiber|copper}
fiber
copper
It is optical interface attribute by default.
Set the optical/electrical attribute of the gigabit Ethernet port to
optical interface attribute with the hybrid-attribute fiber com-
mand. Set the optical/electrical attribute of the gigabit Ether-
net port to electrical interface attribute with the hybrid-attribute
copper command.
This example describes how to set the optical/electrical attribute
of interface gei_1/1 to electrical interface attribute.
ZXR10(config)#interface gei_1/1
ZXR10(config-if)#hybrid-attribute copper

interface

The execution of this command enters the interface configuration
mode or the sub-interface configuration mode. For an inexistent
sub-interface, create a sub-interface and enter the sub-interface
configuration mode. To delete the corresponding interface and re-
lated configurations, use the no form of this command.
Global configuration
interface {<interface-name>| byname <byname>}
no interface {<interface-name>|<byname>}
Configures the attribute to optical interface
attribute
Configures the attribute to electrical interface
attribute