Oam-Pvc; Show Atm Pvc - Zte ZXR10 Command Manual

This command is only applied to ZXR10 GER and ZXR10
Instruction
T64E/T128.
This example describes how to configure PVC retry times.
Example
ZXR10(config)#interface atm155_1/1.1
ZXR10(config-if)#oam retry 2 2 2

oam-pvc

Use this command to enable oamF5 management on PVC. Disable
Function
the function with the no form of this command.
Interface configuration
Command Mode
oam-pvc manage [<frequency>]
Syntax
no oam-pvc [manage][<frequency>]
Syntax
Description
�
Instructions
�
This example describes how to enable oamF5 management on the
Example
PVC.
ZXR10(config)#interface atm155_1/1.1
ZXR10(config-if)#oam-pvc manage 2

show atm pvc

Use this command to show the configured PVC connection and its
Function
configuration parameters.
All modes except user mode.
Command Mode
show atm pvc [<interface-name>|<vpi><vci>]
Syntax
manage
<frequency>
It is applied to ZXR10 GER and ZXR10 T64E/T128.
Special note of the command no oam-pvc [manage][<frequ
ency>]:
The command no oam-pvc restores the default frequency
�
(5 seconds) and disables the function.
The command no oam-manage manage remains the orig-
�
inal frequency unchanged and disables the function.
The command no oam-pvc manage <frequency> re-
�
places the original frequency with frequency (effective at
next startup) and disables the function.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 ATM Protocol Configuration
Enables the oam management on the PVC
Frequency (in seconds) at which the oam
f5 management cell is sent, range: 1~600,
default: 5 seconds
9