Set Interface Cancel; Set Interface Duplex - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
broadcast-limit

set interface cancel

Use this command to configure the link up/link down alarm and
the SNMP TRAP information of the shielding ethernet interface in
batch scale.
Global configuration
set interface cancel <up-down-type><port-list>
<up-down-type>
<port-list>
This example shows how to configure the link up alarm and the
SNMP TRAP information of the shielding interface fei_1/1, fei_1/2
and fei_1/3.
ZXR10(config)#set interface cancel up-alarm fei_1/1-3
Cancel

set interface duplex

Use this command to set the work mode of Ethernet ports in batch.
Global configuration
set interface duplex {half | full}<port-list>
half
full
<port-list>
The default is full duplex mode.
Fast Ethernet electrical interfaces, and Gigabyte Ethernet electrical
interfaces support both half and full duplex work modes. Fast Eth-
ernet optical interfaces, Gigabyte Ethernet optical interfaces and
10 Gigabyte Ethernet interfaces support only the full duplex mode.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
The value is down-alarm or up-alarm.
down-alarm: shields the link down alarm and
SNMP TRAP information
up-alarm: shields the link up alarm and SNMP
TRAP information.
Specifies the port list to configure in batch
scale.
Sets the work mode of Ethernet ports to the
half duplex mode.
Sets the work mode of Ethernet ports to the
full duplex mode.
Port list of the batch configuration
45