Vrrp Learn - Zte ZXR10 Command Manual

ZXR10 Command Manual (Basic Configuration Volume II)
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
132 Confidential and Proprietary Information of ZTE CORPORATION
Do not set to the same virtual address as the current group
�
on the interface.
Do not set to the same virtual address as the other group
�
on the interface.
Do not set to the same virtual address as any group on the
�
other interfaces.
Do to set to one address that will be in the same subnet as
�
that of the other interfaces.
Do not repeat the address of the other interfaces.
�
�
The no command will delete all the settings of this group if no
IP address is specified.
� The primary virtual IP address of a group is unique. If the
primary virtual IP address is configured several times. The
last configuration will overwrite the previous configurations.
This example describes how to run the VRRP protocol on the in-
terface and configure the primary virtual IP address of the VRRP
virtual router (ID 1) as 10.1.1.1.
ZXR10(config)#interface vlan 1
ZXR10(config-if)#vrrp 1 ip 10.1.1.1
show vrrp

vrrp learn

Use this command to configure how to know the VRRP message
send time interval on the interface. Restore the default with the
no command.
Interface configuration
vrrp <group> learn
no vrrp <group> learn
<group>
The learn mode is not configured by default.
When the learn mode is configured, the time interval of the mas-
ter's sending VRRP messages will be learned from the intercepted
VRRP messages. Otherwise, the time interval of the master send-
ing VRRP messages will be the local configuration.
This example describes how to configure the learn time interval of
the Master sending VRRP messages.
ZXR10(config)#interface vlan 1
ZXR10(config-if)#vrrp 1 learn
Virtual router ID, 0 ~ 255