Vtg E1 Channel-Group Timeslots; Vtg E1 Clock Source - Zte ZXR10 Command Manual

ZXR10 Command Manual (Basic Configuration Volume II)
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
70 Confidential and Proprietary Information of ZTE CORPORATION
It is applied only to ZXR10 GER.
This example describes how to enter the vt-2 configuration mode.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sonet
ZXR10(config-control)#sts-1 1
ZXR10(config-control)#mode vt-2
ZXR10(config-control)#vt-2 1
vtg e1 channel-group
timeslots
Use this command to create an E1 channel when the cpos3 inter-
face is configured with the sonet mode and the sts-1 is configured
with the vt-2 mode. Delete the specified E1 channel with the no
command.
Channelization configuration
vtg <vtg-number> e1 <line> channel-group <channel-numb
er> timeslots <timeslots>
no vtg <vtg-number> e1 <line> channel-group <channel-num
ber>
<vtg-number>
e1 <line>
channel-group
<channel-number>
timeslots <timeslo
ts>
It is applied only to ZXR10 GER.
This example describes how to create an E1 channel.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sonet
ZXR10(config-control)#sts-1 1
ZXR10(config-control)#mode vt-2
ZXR10(config-control)#ctg 1 e1 1 channel-group 1 timeslots 1-31

vtg e1 clock source

Use this command to set the clock source of E1 channel when the
cpos3 interface is configured with the sonet mode and the sts-1 is
configured with the vt-2 mode. Restore the default value with the
no command. .
Channelization configuration
vtg number, 1 ~ 7.
E1 number, 1 ~ 3
E1 channel number, only 1.
Timeslot number, distribute the timeslots of 1
to 31 to a channel on the one-off basis.