Clock Board Source; Clock Source - Zte ZXR10 Command Manual

Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
This example describes how to clear the statistics data on interface
fei_5/1 .
ZXR10#clear counter fei_5/1
show interface

clock board source

Use this command to select single board source.
Global configuration
clock board source {free-run | system | line <interface-nam
e>}
no clock board source
free-run
system
line <interface-na
me>
Default is system.
This example describes how to use single clock board as clock
source.
ZXR10(config)#interface pos48_1/1
ZXR10(config-if)#exit
ZXR10(config)#clock board source pos48_1/1 free-run

clock source

Use this command to configure the clock extraction mode of the
interface in local router. Restore default with the no command.
Channelization configuration and interface configuration
clock source {internal | line}
no clock source
line
internal
The clock mode is internal.
This command runs in the controller configuration mode on CE1,
CE3 or CT1 interface, and the interface configuration mode on pos
or atm interface.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
Single clock board source
Use SFC as single clock board source
Use line clock as clock source and interface,
not support sub interface
Line clock
Internal clock
15