Tug-2 E1 Clock Source; Tug-2 E1 Framing - Zte ZXR10 Command Manual

ZXR10 Command Manual (Basic Configuration Volume II)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
66 Confidential and Proprietary Information of ZTE CORPORATION

tug-2 e1 clock source

Use this command to set the clock source of the E1 channel when
the CPOS3 interface is set to the SDH mode, and the AUG is in the
AU-4 mapping mode. Restore the default with the no command.
Channelization configuration
tug-2 <tug-2-number> e1 <line> clock source {internal |
line}
no tug-2 <tug-2-number> e1 <line> clock source
tug-2 <tug-2-numb
er>
e1 <line>
internal
line
Internal means the internal clock by default.
It is applied only to ZXR10 GER.
This example describes how to set the line clock as the clock source
of the E1 channel.
ZXR10(config)#controller cpos3_3/1
ZXR10(config-control)#framing sdh
ZXR10(config-control)#aug mapping au-4
ZXR10(config-control)#au-4 1 tug-3 1
ZXR10(config-control)#tug-2 1 e1 1 clock source line

tug-2 e1 framing

Use this command to set whether the E1 channel works in the
frame mode and what the frame format is when the CPOS3 inter-
face is set to the SDH mode and the AUG is in the AU-4 mapping
mode.
Channel configuration
tug-2 <tug-2-number> e1 <line> framing {unframe | frame |
crc4 | no-crc4}
tug-2 <tug-2-numb
er>
e1 <line>
framing
tug-2 number, ranging 1–7
E1 number, ranging 1–3
Sets the internal clock as the clock source of
the E1 channel.
Sets the line clock as the clock source of the
E1 channel.
tug-2 number, ranging 1–7
E1 number, ranging 1–3
Sets the E1 channel to work in the unframe
mode.