Load-Balance; Load-Interval - Zte ZXR10 Command Manual

Command Modes
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
CE1, CT1 controller configuration
linecode {ami | bz8s}
ami
bz8s
The linecode is bz8s by default.
1. This example describes how to set the linecode of interface
CE1.
ZXR10(config)#controller ce1_3/1
ZXR10(config-control)#linecode ami
ZXR10(config-control)#linecode bz8s
2. This example describes how to set the linecode of interface
CT1.
ZXR10(config)#controller ce3_3/1
ZXR10(config-control)#linecode ami
ZXR10(config-control)#linecode bz8s

load-balance

Use this command to set not to send MPPP packets in fragments.
Use the no command to adopt fragment sending.
Interface configuration

load-balance

no load-balance
Fragment sending is not adopted.
It is applied only to ZXR10GAR, ZXR ZSR.
This example describes how to send the data of interface multilink1
in fragments.
ZXR10(config)#interface multilink1
ZXR10(config-if)#no load-balance

load-interval

Use this command to set up the interface traffic statistic interval.
Restore the default with the no command.
Interface configuration
load-interval <interval>
no load-interval
<interval>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 Interface Configuration
ami linecode
bz8s linecode
Statistical interval(in seconds), ranging
30–600, 120 seconds by default
33