HID Fargo HDP8500 User Manual page 169

© 2012 HID Global Corporation. All rights reserved.
(PC Error Message
No. 201, 211)
No Mag Module
(PC Error Message
No. 31)
No Ribbon
(PC Error Message
No. 25, 100)
Printing Error
(PC Error Message
No. 107)
Printhead thermistor
error
(PC Error Message
No. 8)
Printhead Temp Error
(PC Error Message
Nos. 9,67)
Remove Card
(PC Error Message
No. 68)
HDP8500 Industrial Card Printer/Encoder User Guide
sided Printer.
No flipper module is installed
in the printer.
The laminate is in the wrong
position for the side they
want to laminate, and they
don't have a flipper.
MAG encoding job sent to
Printer without a MAG
Encoder.
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type.
No Ribbon is installed in the
Printer.
OR
The Ribbon RFID tag is bad.
An error was detected during
printing.
The Printhead Temperature
Sensor is not functioning or
is not connected properly.
OR
The Printhead is not cooling
properly.
Unspecified system error
detected by the Printer
Firmware.
A card is jammed in the Print
Station or card flipping area
of the Printer.
capabilities via the LCD Menu.
If Flipper capabilities are present,
ensure that the Print Both Sides
option in the Driver is set correctly.
Press the Resume button on the
Printer‟s Front Cover to continue
printing.
To cancel the print, press the Cancel
Print button from the Driver‟s display
dialog.
Install the correct Ribbon and press
the Resume button located o the
Printer‟s LCD display.
To cancel the print, press the Cancel
Print button from the Driver‟s display
dialog and the Cancel button located
on the Printer‟s LCD display.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
If the problem persists, call for
technical assistance.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Clear the jam and press Cancel.
L001617 rev 1.1
169