HID Fargo HDP8500 User Manual page 171

© 2012 HID Global Corporation. All rights reserved.
System Fault
(PC Error Message
No. 286)
Start Film Release
Error
(PC Error Message
No. 160)
Unable to Feed
(PC Error Message
Nos. 14, 297, and 81)
Utility Error
(PC Error Message
Nos. 129)
Wrong Film
(PC Error Message
Nos. 162 and 163)
HDP8500 Industrial Card Printer/Encoder User Guide
Unspecified system error is
detected by the Printer
Firmware.
The mag encoder module
suffered a fatal error. Reboot
the printer.
An error has occurred during
the transfer release phase.
The Printer is unable to feed
a card from the Card
Cartridge
Command resulted in an
error.
The print film installed in the
Printer does not match the
film type selected in the
Printer Driver.
OR
A Self-test job cannot be
printed with the print media
installed.
An invalid OEM film was
installed in the printer.
printing.
To cancel the print, press the Cancel
Print button from the Driver's display
dialog.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Verify there are cards in the Card
Cartridge.
Verify cards are not stuck together or
jammed, and they are the correct
thickness.
Fan cards to remove excess static.
Break apart any cards that are edge
welded or stuck together. Check to
see if card weight is present. Reboot
printer.
See Resolving the Communication
Errors.
Replace film in Printer with type
specified in the Driver.
A reboot is required.
L001617 rev 1.1
171