HID Fargo HDP8500 User Manual page 179

© 2012 HID Global Corporation. All rights reserved.
No Prox Card
Encoder
Headlift Error
Invalid Password
Laminator (General
Error)
Laminator (Check
Power)
Laminator (Heater
Off)
Laminator (Heater
Timed Out)
HDP8500 Industrial Card Printer/Encoder User Guide
No Proximity Card
Encoder is installed in the
printer.
The Headlift Sensor is not
detecting movement from
the Headlift Cam.
The Password entered is
not a valid password.
The Laminator has
reported a general fault.
The Laminator's power is
OFF.
The Laminator's Heater is
OFF.
The Laminator cannot
reach the desired
operating temperature.
To cancel, click on Cancel Print.
Reboot the Printer by cycling power.
To cancel, press the Cancel Print
button.
Press OK to enter another
password.
To cancel, press the Cancel Print
button.
Press the Resume button located
on the Printer to continue.
To cancel, press the Cancel Print
button or the Cancel button located
on the Printer.
Ensure that the laminator's power
cord is properly connected, cycle
power and press the Resume
button to continue.
To cancel, press the Cancel Print
button or the Cancel button located
on the Printer.
Press the Resume button to
continue.
To cancel, press the Cancel Print
button or the Cancel button located
on the Printer.
a. Reboot the Printer by cycling
power. Check the Laminator
settings in the Printer Driver.
b. Click on the Default button
located on the Lamination Tab
of the driver to set the Laminator
settings to the factory default.
c. Resend the print job.
d. To cancel, press the Cancel
Print button or the Cancel
button located on the Printer.
L001617 rev 1.1
179