HID Fargo HDP8500 User Manual page 163

© 2012 HID Global Corporation. All rights reserved.
No. 69)
Check Film
(PC Error Message
No. 244)
Check Laminate 1
(PC Error Message
Nos. 231)
Check Laminate 2
(PC Error Message
No. 232)
Check Film Error
(PC Error Message
Nos. 26, 158, and
176, 290)
Check Ribbon
(PC Error Message
No. 97, 98, 99)
Cover is Open
(PC Error Message
No. 295)
Expansion Board
Error
(PC Error Message
No. 314, 315, 316)
EEPROM Error
(PC Error Message
No. 38,39,40,44,52)
HDP8500 Industrial Card Printer/Encoder User Guide
The film is not able to move
correctly.
The film has become
jammed or the wrong
number of film marks was
seen during printing.
The Laminator was unable to
find the mark on the material
in cartridge one.
The Laminator was unable to
find the mark on the material
in Cartridge 2.
The film is not able to move
correctly. Check for
jams/breaks.
The Ribbon is not able to
find the next panel correctly.
Check for jams/breaks.
Cover is open and printer
going into pause mode.
An error has occurred on
one of the expansion boards;
Comm Error, ASYNC
Timeout, Timeout
Load cards into Hopper.
Check for jams/breaks.
Verify film is installed correctly in
cartridge.
Remove film and check for any
damage to the film. Scroll film to
unused panel, install film cartridge
and cancel last print job.
Make sure there are no obstructions
to the Sensor, and recalibrate the
Laminator Sensor.
Make sure there are no obstructions
to the Sensor, and recalibrate the
Laminator Sensor.
Check for obstruction.
Verify film is installed correctly in
cartridge.
If the problem persists, call for
technical assistance.
If jammed, clear the jam. If broken,
repair by taping the Ribbon back on to
the take-up core.
Press Resume to continue or Cancel
to abort.
Close printer cover and resume.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
L001617 rev 1.1
163