HID Fargo HDP8500 User Manual page 166

© 2012 HID Global Corporation. All rights reserved.
(PC Error Message
No. 245)
Lam Card Jam
(PC Error Message
No. 53, 212, 214, and
215, 216)
Lam Com Error
(PC Error Message
No. 246)
Lam Card Jam-
Not Ejected
(PC Error Message
No. 216)
Lam Timeout
(PC Error Message
No. 247)
Lam No Film
(PC Error Message
No. 63)
Lam1 Wrong Film
(PC Error Message
No. 237)
Lam2 Wrong Film
(PC Error Message
No. 238)
Laminate 1 Bad
(PC Error Message
No. 233, 235, 227,
225, 223,263, 261,
249)
HDP8500 Industrial Card Printer/Encoder User Guide
Laminator.
A jam occurred somewhere
between the Printer and the
Laminator.
Card can't be ejected from
laminator.
There was a communication
failure between the Printer
and Laminator.
The card is not ejected from
the Laminator.
The Printer timed out while
processing information
related to the Laminator.
No laminate installed in
cartridge
Material in Cartridge 1 of the
Laminator does not match
the material type specified
by the job.
Material in Cartridge 2 of the
Laminator does not match
the material type specified
by the job.
The Lamination material in
Cartridge 1 is not valid for
this Laminator.
The wrong Securemark lam
material was installed in
cartridge.
The wrong OEM material
was installed in cartridge
one.
The wrong grade material
restart the Printer.
Open covers and clear the
obstruction/jam.
The Lamination material is stuck to
the card.
Check Lam power/connections and
restart the Printer.
The Lamination material is stuck to
the card.
Check Lam power/connections and
restart the Printer.
Load Laminate into cartridge.
Make sure Driver material matches
what is actually in the Laminator.
Make sure Driver material matches
what is actually in the Laminator.
Install valid material.
L001617 rev 1.1
166