HID Fargo HDP8500 User Manual page 177

© 2012 HID Global Corporation. All rights reserved.
No Ribbon
Installed
Ribbon Out
Ribbon Break/Jam
Ribbon Miscue
HDP8500 Industrial Card Printer/Encoder User Guide
No Print Ribbon is
installed in the Printer.
The Print Ribbon installed
in the printer is empty.
A Ribbon break/jam has
been detected inside the
Printer.
A Ribbon Miscue has
been detected inside the
Printer.
Install the correct Ribbon and press
Resume on the LCD display.
Install a new Ribbon and press
Resume on the LCD display.
The printer has determined that the
installed ribbon has either jammed
or broken.
a. Open the Printer Cover and
remove the Print Ribbon. If
ribbon is jammed, remove jam
and tighten ribbon.
b. Clear any cards in the printer by
using the Forward and/or Back
buttons located on the Printer's
LCD display.
c. Tape the ends of the Ribbon
together and wind any excess
onto the Take-up Spool of the
Print Ribbon.
d. Re-install the Print Ribbon, close
the Printer Cover and press the
Resume button located on the
Printer's LCD display to continue
printing.
e. To cancel the print, press the
Cancel Print button from the
Driver's display dialog and the
Cancel button located on the
Printer's LCD display.
Open the Printer‟s Cover and
remove the Print Ribbon. Check the
Ribbon and see if it is broken.
a. If the Print Ribbon is not broken,
re-install the Print Ribbon, close
the Printer‟s Cover and press
the Resume button on the
Printer to continue printing.
b. If the Print Ribbon is broken,
tape the ends of the Print
L001617 rev 1.1
177