HID Fargo HDP8500 User Manual page 168

© 2012 HID Global Corporation. All rights reserved.
Lm1 Headlift Err
(PC Error Message
No. 217)
Lm2 Headlift Err
(PC Error Message
No. 218)
Lam 1 Tag Error
PC Error Message
No. 219, 221)
Lam 2 Tag Error
PC Error Message
No. 220, 220)
Lamination Calibrate
Temperature error
No 266
Mag Encoder Paused
(PC Error Message
No. 143)
Mag Verify Error
(PC Error Message
No. 30)
Multiple Feed
(PC Error Message
No. 70)
No Film
(PC Error Message
No. 28, 167)
No Flip Module
HDP8500 Industrial Card Printer/Encoder User Guide
The Laminator failed to
move or sense the lower
(Lam module 1) head.
The Laminator failed to
move or sense the upper
(Lam Module 2) head.
RFID tag write error in lam
cartridge one.
RFID tag lock error in lam
cartridge one.
RFID tag write error in lam
cartridge two.
RFID tag write error in lam
cartridge two.
Lamination Module must be
warm before sending
Calibration option.
The Magnetic Encoder is in
a pause state.
Print could not verify MAG
write.
OR
The magnetic stripe was not
encoded properly.
Multiple cards were fed into
the Printer.
Film is not installed in the
Printer.
OR
Film RFID tag is bad.
Two-sided job sent to a one-
Check head connections and call for
service/repair.
Check head connections, call for
service/repair.
Verify the correct Laminate is installed
in the Lam 1 Cartridge.
Verify the correct Laminate is installed
in the Lam 2 Cartridge.
If not an error will occur and will
trigger the laminator to warm up .
Retry the calibration again after
several minutes.
Check the Cards and click on Cancel
Print.
Remove card from printer and check
for debris or damage on the card. If
card still cannot be verified, reject
card.
Remove all cards and try again.
Install the Film and press Resume.
To cancel the print, press the Cancel
Print button or the Cancel button
located on the Printer.
Verify the Printer has flipper
L001617 rev 1.1
168