HID Fargo HDP8500 User Manual page 170

© 2012 HID Global Corporation. All rights reserved.
Remove Kiosk Jam
(PC Error Message
No. 296)
Remove Lam
Material
(PC Error Message
No. 210)
Remove Lam1
Material
(PC Error Message
No. 204)
Remove Lam2
Material
(PC Error Message
No. 205)
Reject Bin Full
(PC Error Message
No. 265)
Ribbon Out
(PC Error Message
No. 91)
Ribbon Tension
(PC Error Message
No. 98)
Shuttle Jam Error
(PC Error Message
No. 308)
HDP8500 Industrial Card Printer/Encoder User Guide
The printer is in kiosk mode
and a card is stuck under the
kiosk sensor.
Single Sided Lam job
specified but the material is
loaded in both Modules.
Single sided lamination on
the back side is specified but
material is loaded in the Lam
1 Module.
Single sided lamination on
the front side is specified but
material is loaded in the Lam
2 Module.
The reject bin is full.
The print Ribbon has run
out.
The Ribbon tensions may be
out of range.
The Input Hopper Card
Shuttle is jammed.
Clear the jam and press Cancel.
Remove either Lamination Cartridge.
Remove Cartridge 1.
Remove Cartridge 2.
Remove the large number of rejected
cards from the reject bin.
Click OK to clear the notification
message. (Note: In some cases,
rejected cards are incomplete or pose
a security risk, and should be
disposed of properly.)
Install a new Ribbon and press
Resume to continue.
Check and adjust the setting through
the TOOLBOX under the Advanced
Settings tab.
If this problem persists, call for
technical assistance. Press Resume
to continue or cancel to abort.
Open the Printer's Cover.
Clear any cards in the Shuttle Module
by opening the Printers and follow this
direction. #Case Open
Press the Resume button on the
Printer‟s Front Cover to continue
L001617 rev 1.1
170